Blog
How to Program Your ATA PTX4 Remote
Programming your ATA PTX4 remote is hassle free and straight forward. Watch our handy video above or follow our steps outlined below to program your remote quickly today.
Coding to Motor – using original PT-X Remote
Push and hold the door code button on your motor (do not let go of this button). Push and release any button on your new remote two times. Release the Door Code button and test. Tip: The Door Code button has a blue ring around it.
Coding to Receiver - using an original PT-X Remote
Carefully remove the screws from your control box cover. Remove the control box cover and locate your receiver. Tip: Your receiver will have one or two buttons with SW1 and SW2 printed next to them.
Push and hold the SW-1 button on your motor (do not let go of this button). Push and release any button on your remote two times. Release the SW1 button and test. Tip: the SW1 button is usually red or black.
If you want to code to receiver using a compatible PT-X Remote, just follow same steps as above.
Coding via remote – using original and compatible remote
Stand within 1-2 metres of your garage door or gate motor. Press the button on the original remote to open the gate or garage. Place both the new and old remote on a flat surface. Tip: have a pin or paperclip ready for the next step.
Within 10 seconds of the previous step, place a small pin inside the coding hole in the centre of the blue remote and hold in for two seconds then remove the pin. Tip: the light will illuminate when the coding hole has been pushed correctly.