- Open the package and remove the product along with all accessories.
- Unscrew the antenna by rotating it anticlockwise.
- Use the bracket's fixing hole to mark two holes on the wall.
- Drill two holes with a 6mm diameter and one hole with a 10mm diameter.
- Insert expansion plugs into the 6mm diameter holes. Thread the wires through the 10mm diameter hole.
- Route the power wire and antenna through the cable holes in the bracket, then secure the bracket to the wall using the provided 4mm x 30mm self-tapping screws.
- Feed the power wire and antenna through the cable holes in the bottom base. Attach the bottom base to the bracket using the supplied 4mm x 10mm screws.
- Connect the wire and antenna to their respective terminals.
- Reattach the cover, ensuring it fits snugly with the bottom base and leaves no gaps.
- Screw the antenna back in, turning it clockwise to tighten.
- Ensure that both the bracket and lamp are installed upright relative to the ground. Installing them horizontally could allow water to enter the lamp, potentially damaging the circuit board.
WARNING! This product may contain a button/coin cell battery. To prevent possible SERIOUS INJURY or DEATH:
- Keep new and used batteries out of reach of children at all times.
- Do not use the product if the battery compartment is damaged or doesn’t close securely.
- Dispose of used batteries immediately and safely - even flat batteries can cause harm.
- Do not ingest the battery. Chemical burn hazard.
- Act fast if you suspect a battery has been swallowed or inserted - severe or fatal injuries can occur within 2 hours.
- Seek immediate medical attention or call:
– Australia: Poisons Information Centre on 13 11 26
– New Zealand: National Poisons Centre on 0800 764 766
Remote Pro supplies aftermarket products designed to be compatible with and to suit a wide range of original brands. Unless a product is expressly stated to be genuine, all items sold on this website are not manufactured, authorised, endorsed, or approved by the original equipment manufacturers (OEMs).
References to brand names, trademarks, or model numbers are used solely to indicate compatibility or suitability for use with the respective equipment. Remote Pro is not affiliated with, sponsored by, or associated with any of these brand owners, and no OEM approval or endorsement is implied.
All trademarks, brand names, and product names remain the property of their respective owners. Remote Pro distributes a range of aftermarket products, including but not limited to remote controls compatible with garage and gate motors and receivers produced by other manufacturers, as well as substitute automotive keys, remote controls, and casings designed to be compatible with vehicles made by other manufacturers.