FAAC Mounted Wireless Photo Beams (Photo Electric / Photocells) Model
System with traditional 12/24V power supply for the receiver and traditional or battery-powered transmitter. It eliminates the need for wiring to the transmitter (battery-powered) and features selectable channels, allowing for the installation of up to 4 pairs of photocells and protection from interference from external light sources (e.g., LED car headlights).
Modulated infrared transmitter and receiver
The XP 20 D orientable photocells consist of a modulated infrared transmitter and receiver with a range of up to 20 m. Obscuring the light beam causes the receiver to change state.
Precise and reliable regulation
The photocell is housed on a rotating support equipped with a high-performance lens designed to optimize the efficiency of the beam in any direction.
The rotating stand is locked in the desired position thanks to a sturdy snap-on rotation lock (removable with a screwdriver if necessary).
Specifications:
• Sold as a pair (sender and receiver)
• 180°Horizontal Beam Adjustment
• 12/24v (AC/DC)
• Wireless + Hard Wired; 4 pairs of beams on the same system
• Use 0.5mm² Cable to wire in
• Possibility for cable inlet from the back and the underside
• Obstacle Detection Time; Wireless: 40ms
Range:
• Wireless = Max. 8m
• Hard Wired + BUS = Max. 20m
Please Note:
• You are still required to run a wire from one photo beam to the control box
• The other photo beam is wireless and is powered by 1 x CR2 3V battery (supplied)
• If connecting the wireless beams to an FAAC ‘Standard’ E024S Swing Gate Control Board, you will need to install an FAAC BUS Interface #1059-0010
Country: BULGARIA
Dimensions: 130mm H x 41mm W x 42mm D
Material: Black Plastic
Power Supply: 12/24v OR Battery operated transmitter - 3VCR2
Remote Pro
WARNING! This product may contain a button/coin cell battery. To prevent possible SERIOUS INJURY or DEATH:
- Keep new and used batteries out of reach of children at all times.
- Do not use the product if the battery compartment is damaged or doesn’t close securely.
- Dispose of used batteries immediately and safely - even flat batteries can cause harm.
- Do not ingest the battery. Chemical burn hazard.
- Act fast if you suspect a battery has been swallowed or inserted - severe or fatal injuries can occur within 2 hours.
- Seek immediate medical attention or call:
– Australia: Poisons Information Centre on 13 11 26
– New Zealand: National Poisons Centre on 0800 764 766
Remote Pro supplies aftermarket products designed to be compatible with and to suit a wide range of original brands. Unless a product is expressly stated to be genuine, all items sold on this website are not manufactured, authorised, endorsed, or approved by the original equipment manufacturers (OEMs).
References to brand names, trademarks, or model numbers are used solely to indicate compatibility or suitability for use with the respective equipment. Remote Pro is not affiliated with, sponsored by, or associated with any of these brand owners, and no OEM approval or endorsement is implied.
All trademarks, brand names, and product names remain the property of their respective owners. Remote Pro distributes a range of aftermarket products, including but not limited to remote controls compatible with garage and gate motors and receivers produced by other manufacturers, as well as substitute automotive keys, remote controls, and casings designed to be compatible with vehicles made by other manufacturers.