Blog

Need to programme your Ford Falcon remote? No worries, the team at RemotePro have you covered. Just follow the step by step guide in the video above or read through the instructions below. View our full range of car remotes today.

Step-by-Step Instructions

1. Prepare: Sit in the car with your keys and remotes ready
2. Close the Door: Close the driver side door
3. Ignition: In less than 10 seconds of closing the door, insert the key into the ignition and turn the key to the first click (accessories position) which will turn on the radio
4. Rear Demist Button: In less than 3 seconds of turning the key, press the rear demist button 3 times
5. Check Door Locks: If done correctly, the door locks will cycle. If the door locks do not cycle, start the process again and try completing the steps faster or slower.
6. Learn Mode: Once in learn mode all existing remotes will be deleted from the car’s memory. Click any button on the remote until you hear the door locks cycle. Once the locks cycle this confirms the remote has been accepted into the car’s memory.
7. Repeat for Additional Remotes: Repeat the last step for each remote (if you can have more than one)
8. Completion: Remove the key and step out of the car and test each button on the remote is performing it’s proper function.

Now you can enjoy the convenience of a perfectly programmed Ford Falcon remote. If you have any questions or need further assistance, feel free to contact us. 

For more helpful tips and automotive solutions, stay tuned in our blog. If you found this guide valuable, don't forget to share it with your fellow Ford Falcon owners who might be facing the same issues. 

Programming your ATA PTX4 remote is hassle free and straight forward. Watch our handy video above or follow our steps outlined below to program your remote quickly today. 

Coding to Motor – using original PT-X Remote

Push and hold the door code button on your motor (do not let go of this button). Push and release any button on your new remote two times. Release the Door Code button and test. Tip: The Door Code button has a blue ring around it.

Coding to Receiver - using an original PT-X Remote

Carefully remove the screws from your control box cover. Remove the control box cover and locate your receiver. Tip: Your receiver will have one or two buttons with SW1 and SW2 printed next to them.

Push and hold the SW-1 button on your motor (do not let go of this button). Push and release any button on your remote two times. Release the SW1 button and test. Tip: the SW1 button is usually red or black.

If you want to code to receiver using a compatible PT-X Remote, just follow same steps as above.

Coding via remote – using original and compatible remote

Stand within 1-2 metres of your garage door or gate motor. Press the button on the original remote to open the gate or garage. Place both the new and old remote on a flat surface. Tip: have a pin or paperclip ready for the next step.

Within 10 seconds of the previous step, place a small pin inside the coding hole in the centre of the blue remote and hold in for two seconds then remove the pin. Tip: the light will illuminate when the coding hole has been pushed correctly.